Make sure all of the parts of your hotend are tightened. Especially where the Teflon tube ends. I set up a new printer once and it was having similar issues and it ended up the nozzle wasn’t fully tightened and was getting plugged up in the small gap. Changed the nozzle, cleaned the plugged material out, and made sure everything was tight, and it started printing just fine. Most PLA should print well at 200.
Looks like a character in a Wes Anderson film.
There’s no paint on the planet that will make most of their cars cool.
According to Hermes, technically correct is the best kind of correct.
Who the hell goes to a bar to order water?
Sounds lovely. /S